28 May
2019
28 May
'19
3:45 p.m.
I've never seen one exactly like that before either. You might want to make a mold and
create one that way.
Dwight
________________________________
From: cctalk <cctalk-bounces at classiccmp.org> on behalf of William Donzelli via
cctalk <cctalk at classiccmp.org>
Sent: Tuesday, May 28, 2019 6:42 AM
To: Bob Rosenbloom; General Discussion: On-Topic and Off-Topic Posts
Subject: Re: looking for an old IBM knob from a 609 calculator panel
I think that is an IBM specific knob. I will keep an eye out for one,
but do not hold your breath! It is certainly not a common knob.
Is it for a 1/4 inch shaft?
--
Will
On Mon, May 27, 2019 at 11:41 PM Bob Rosenbloom via cctalk
<cctalk at classiccmp.org> wrote:
A long shot I know, but I'm looking for an IBM knob that's missing from
a 609 calculator panel I have.
Photos can be seen here:
http://dvq.com/ibm/ibm-609-pnl1.JPG
http://dvq.com/ibm/ibm-609-pnl4.JPG
http://dvq.com/ibm/ibm-609-pnl5.JPG
I have no idea if the knob was made by IBM or was a common knob of the
times.
Thanks,
Bob
--
Vintage computers and electronics
www.dvq.com<http://www.dvq.com>
www.tekmuseum.com<http://www.tekmuseum.com>
www.decmuseum.org<http://www.decmuseum.org>
