3 May
2015
3 May
'15
6:16 p.m.
On 05/03/2015 04:23 PM, Jules Richardson wrote:
I'm not sure what, if anything, I can do about the serial console - is
there a way of defaulting to console on port B rather than on port A?
Not quite what you might be looking for, but: Run "printenv" at the "ok
" prompt, you should see two variables to set the console input and
output. "ttyb" should do the trick IIRC.
Remember, that'll get lost if the battery dies or gets disconnected...
--S.