3 Aug
2001
3 Aug
'01
8:02 a.m.
Ok, so my DECServer has to boot its image rather than
run it from flash.
Not a problem, however when the system reboots it loses all of its
configuration information as far as I can tell. Is this normal? Is there no
NVRAM inside or perhaps I've got a dead battery somewhere? Alternatively,
is there some way to "upload" the configured image such that I could boot
_that_ and thus be preconfigured?
The configuration information should be saved. Are you using change,
define, or set? If you you set, only the volatile configuration is
changed. define changes only the permanent configuration, and change
changes both.
--
Eric Dittman
dittman(a)dittman.net