TU58 yet one more time.

I have been fiddling with a TU58-EX device, dual TU58 drives in a small box. The capstans is replaced. I used silicone tubing which I glued on and then sanded down a bit. PVC tubing in a size that would fit seems to be unavailable in Sweden. The two capstans were a little bit different in diameter at first. Drive one closer to 17 mm but drive zero around 16.5mm. Drive zero read 5 of 8 tapes (two more tapes had belt breakage). One tape gave "Invalid Directory" in RT11 the two other gave "Error reading directory". On drive one just one tape was readable. So the decision was to get closer to the nominal 5/8" (which I read was the OD in a post by Tony Duell). With both drives at 16mm drive zero still read the same amount of tapes and drive one read the same tapes plus one more which was not readable on drive zero. Highly annoying. So I decided to read more on the TU58. The spec says that the bit time is 41.2 us. When I measure I get reading of between 42 and 44 us. (Yes I should have measured before trimming the capstans). So now the tape is too slow. Although the OD is slightly above the nominal. Is silicone tubing too soft? Having been working on a project to recover a tape from a Zilog S8000 machine together with AJ (http://mightyframe.blogspot.se/) I just thought that it might be possible to read the TU58 and HP DC100 tapes with some other hardware doing post processing in a regular Linux box. Would it be possible to use a Floppy Tape (QIC-117) tape drive to read them? It appears that the tapes are not identical in size. A DC1000 is 0.25 " while the DC100 is 0.15". The capstan position would also differ. Are there other physical differences that I am not aware off? Since the TU58 drive is not able to format a tape it could be useful to also write a new tape with TU58 format. But I guess that there are difference in coercivity between different tapes. I have read that Rik Bos successfully converted HP85 drives to take DC1000 tapes by modifying the capstan and changing the write current. Before I go ahead buying some old Colorado T1000 drive dirt cheap I just like to ask if this project is doomed because of whatever reason. /Mattis