New old products :)

I?ve gotten back into my Atari systems again and since I had a couple Indus GT drives, I found a schematic for the RAM upgrade board for the drives, and had PCB?s made :) my first professionally produced PCB?s in 20+ years. I?m quite pleased since it was a first effort with new software when I hadn?t touched EDA software in 20 years or so. Lessons learned were: Increase PAD size :) these are solderable, but are just a touch too small by the software default. Validate that pin one indicators REALLY render out to the gerbers. I have to refer back to my PCB design for pin one since it didn?t render. Quadruple check that all wires and nets are present. I discovered that a trace between 2 pins on the connector(s) disappeared on me at some point during editing, it is entirely possible I deleted it like an ID10T. So for this run of boards, wire-wrap wire will be my friend to jumper the 2 pins at the PCB.