16 May
2014
16 May
'14
12:02 a.m.
Hi Marco,
I wish I had one!
If I recall correctly, some of the boards like the G888, depends on which
controller you are using. There may be other differences between the system
it is used on, PDP 8, PDP11, etc.
Good luck, Paul
On Fri, May 16, 2014 at 1:42 AM, Marco Rauhut <marco at familie-rauhut.eu>wrote:
Hello ClassicCMP`s
I`am resorating an TU56 dual drive. It is clean now, i repaired the
powersupply, i formated the capacitors and i checked if all modules that
needed are existing.
My question before first "smoke test" is done is....
In the engeneering drawings "Module Utilization" are shown special places
for each module. In my drive the Modules on different places then in the
drawing.
Is the backplane a real bussystem or got i use the ports shown in drawings?
Marco
P.S.: Is it allowed to send pictures as attatchment to the list? Or wants
the moderator killing me when i do?