Resistor/Fuse replacement (DEC H7104-D)

Hi all -- Yesterday I replaced the dead 2N6547 transistor in the H7104 and fired 'er up again. Same exact results. (The timbre of the power supply whine may have changed slightly, it's hard to tell). So, back to the drawing board. I tested the replacement transistor after power-up and it was still good, so at least it wasn't a casualty. On closer inspection, I found what appears to be a large-ish (maybe 2.5-3mm in diameter) resistor with a hairline crack down the middle. Testing reveals it to be open-circuit, and looking at the print set reveals it to be connected to a leg of the transistor I just replaced, so that seems suspect. I noted no smoke or odor during any of the times I've powered this thing up (the resistor is on the outside edge of the supply and I was watching pretty closely at all times) so I assume it was dead long before I got ahold of this machine and I just overlooked it. It's listed in the print set as a 1 Ohm, 2 Watt resistor, with a "FUSE" designation. I'm not entirely sure what I should be searching for for a replacement; clearly the "fuse" part of the designation is important but I'm not sure what a modern equivalent is. I've browsed around Mouser for awhile and I'm not seeing anything obvious. I'm sure this is obvious to anyone with experience -- can you point me in the right direction? Thanks, Josh