5 Aug
2016
5 Aug
'16
10:23 p.m.
Okay so.. I decided to try the MP-C board out, just for kicks. ?No change.
Then I decided to add one of the RAM boards.. the next one up in addresses. ?Got a little
bit when I powered on. ?Added one of the old MPM boards.. one that has memory chips all
piggybacked on one another. ?Now when I powered up, the system was sending four or five
characters at a time, linefeed, four or five characters at a time, linefeed ad infinitum.
?I added the final MPM board.. zero.
So.. I think we do have some ram problems.. most likely. ?I'm thinking it would be
easiest to concentrate efforts on the socketed RAM boards.. test all the RAM out. ?I'm
going to read up on addressing and try to understand a bit better what is going on.
?I'm thinking maybe I need to reconfigure the addressing on one of the boards to match
whatever that overstuffed MPM board is set to.
Until I get an oscilloscope.. fooling around is about all I can do here.
Sent from my Samsung device
-------- Original message --------
From: Chuck Guzis <cclist at sydex.com>
Date: 2016-08-05 3:55 PM (GMT-08:00)
To: "General Discussion: On-Topic and Off-Topic Posts" <cctalk at
classiccmp.org>
Subject: Re: SWTPC 6800
On 08/05/2016 02:15 PM, Brad H wrote:
I think I will have to figure out how to do that.?
Additionally I
have one of those PC based oscilloscopes on the way.? I don't know
how to use them 100% but I'm about to learn I guess. :)
I have one more question for you guys -- I have a few CT-1024
terminals and would really like this system to work with one of
those.? However, all of the CTs are quite delicate and are set I
think for 7, E, 2 @ 110 baud via soldered jumpers.? I'm a bit
reluctant to try pulling them apart to get in there and fix that.? Is
there a way to change the parity, etc settings on the SWTPC to match
the terminal?? Is it necessary?
Well, 110 bps is a bit on the slow side--great for teletypes, not so
much for video terminals.?? But you'll have to change the hardwired
jumpers--the UART used in the CT1024 is not software-programmable.
If this were my unit, I"d probably solder some pins into the pad holes
and then either use slide on jumpers or wirewrap to set the
characteristics.? That way, when changing things around, you won't be
stressing the PCB.
Something like this:
http://www.ebay.com/itm/10PCS-20CFemale-to-Female-1-Pin-Plug-Jumper-Cable-W…
Search on "female jumper wires"
--Chuck