25 Feb
2011
25 Feb
'11
12:49 p.m.
On Friday (02/25/2011 at 08:02PM +0000), Tony Duell wrote:
But maybe this would keep the (normally) upward facing head from
crashing then?? :-)
I still don't know which head is which but I have determined that neither
head is completely borked in the drive I am working on. I don't start
getting errors until out around cylinder 490 or so... before that,
it reads without error. So, that is much more hopeful. Just need to
run through the cal / adjustment procedures and see if I can't bring it
back into line.
Part of that process will reveal to me which head is which... as I will
see the results of the head the software selects on a scope.
Thanks for the input on the issue though. It is appreciated.
Chris
--
Chris Elmquist
What hapens when a RL02 is installed upside down :-)
You have a devil of a job getting the pack and pack cover in. The latter
is likely to fall out before you can close the cover.