19 Dec
2009
19 Dec
'09
5:44 p.m.
It is a 6 pin IDP connector. Rectangular. One can
make up a tail to
get to it by using a 6 pin IDP and a short ribbon cable.
I don't think it is. I agree it's the same spacing (I thought it was
smaller, but I just measured the one on my 6150 monitor), but I don't
think there's room at the ends for the clamps that hold an insulation
displacement block together.
It's polarised by the overlap of the metal shell, and the rubber
moulding around it, not by any of the keys normally found on IDCs.
Philip.