20 Oct
2016
20 Oct
'16
1:47 p.m.
On Thu, 20 Oct 2016, william degnan wrote:
On Thu, Oct 20, 2016 at 4:25 PM, Jason Howe <jason
at smbfc.net> wrote:
I would if I had a spare ST251-1 hanging around. I've been tempted to
order one from the flea-bay for just such an experiment.
--Jason
On Thu, 20 Oct 2016, Mike Stein wrote:
I've got several ST251-1s that spin up just fine, no funny noises, but
Can you swap the controller board of the drive with another drive's?
then do a bunch of back-and-forth seeks and shut
down again.
It's the usual, "they worked fine the last time;" any ideas what the
problem is and if there's anything that can be done? Presumably it's having
trouble finding the sync track; weak signal? Any ideas?
m
I'm actually trying to bring an ST251-1 back to life right now. It
worked, then was intermitently not recongnized by the controller after
being powered on for a while, now not recognized at all. When you apply
power it runs through whatever standard head-sweep routine (self-test?),
but there seems to be a communication breakdown between the Drive
electronics and controller board.
Various sources on the interwebs suggest me that the small SMD tant caps
by the power connector are a known issue on these drives and can lead to
all sorts of flaky behavior.
I've orderd a few from digikey, hopefully will have them by this weekend
to attempt a repair.
See my forum post here, where my shoot-in-the dark analsys is disagreed
with: http://www.vcfed.org/forum/showthread.php?54516-Caps-for-an-ST251-1:
--Jason