9 May
1999
9 May
'99
5:25 a.m.
Hi,
On Fri, 7 May 1999 Tony Duell wrote:
Take off the spring. I believe that you can normally
take the collet
apart further, but this isn't in the manual. Apply a smear of grease
(either plastic grease or vaseline) to the spindle and reassemble. Put
the spring on with the smaller end against the collet.
Tried doing that, and it didn't help. It turns out that the C-clip was
vibrating, causing the noise; I should probably have figured that out sooner.
Putting some grease in the groove that the clip fits into solved the problem. I
guess using a hot-melt glue gun would do the job too. (Maybe this info will be
of use to someone in future?)
-- Mark