13 Mar
2019
13 Mar
'19
10:35 a.m.
On Wed, Mar 13, 2019 at 10:29 AM Zane Healy via cctalk <
cctalk at classiccmp.org> wrote:
Yes, you will need to apply the patches (I believe patch #448 is the one
you need, but why not apply them all...), they fix the MSCP drivers & boot
code for the Viking and CMD SCSI controllers.
- Josh
On Mar 13, 2019, at 10:15 AM, Bill Gunshannon via
cctalk <
cctalk at classiccmp.org> wrote:
Anybody had any luck with this configuration?
I used VTServer to install it and everything works fine
except for the very last step. It installs completely
and boots from within VTServer with ra(0,0,0)unix. I
issue the "dd if=/mdec/rauboot of=/def/rra0a count=1" and
it completes successfully. But the disk still won't boot.
I have tried it three times now with the same results.
Suggestions?
bill
Are all the patches applied? IIRC, some of the later patches were around
SCSI support. I know one of them is required for Viking QDT support, not
sure about CMD. Mind you, I?ve never installed any flavor of UNIX on my
PDP-11?s.
Zane