20 Feb
2017
20 Feb
'17
3:44 p.m.
From what I have seen, yes. There is a Hex version of
this board for the 8/A. the product for the E was a 2 board set. Each pair of boards had
16k X 12 bit. So two pair of boards are required. I have two pair but have some stuck bits
I need to figure out.
-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Doug Ingraham
Sent: Monday, February 20, 2017 3:38 PM
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: DATARAM DR-118 docs?
On Sat, Feb 18, 2017 at 10:09 PM, W2HX <w2hx at w2hx.com> wrote:
Hi folks,
Looking for documentation on the DATARAM DR-118 16Kx12 core memory for
PDP-8/e. I have the documentation on the DR-118A which is for the PDP-8/a.
It is probably similar, but would love to find the right version.
Anyone have such thing?
Thanks
Eugene
I don't have an answer for you only an additional question.
Since the E came out before the A and DATARAM made a board for the E, and quad boards from
the E would work perfectly in the A why would you make a board specifically for the A?
Did they make a Hex board version of it for the A? Was the E a two board set?
Hope you find the documentation.
--
Doug Ingraham
PDP-8 SN 1175