26 Jul
2005
26 Jul
'05
9:45 p.m.
Ok, i bite a little bit in the dust ...
... and searched for the manual. It's the "Peripheral Installation Guide"
(97005-90000).
It says : use address 2 if only one other disc drive is available beside the 9122,
use address 3, if there are two drives. This applies to 9121 as well.
The more important sentence is : 9121/9122 are supported for Series 200 with Boot Rom 3.0
or later and Boot Rom Rev.A for all Series 300 systems ...
On Tue, 26 Jul 2005 00:25:57 +0100 (BST), Tony Duell wrote:
Hope that helps !
Ciao Bernd
... i've
done that. I had a 9122 connected to a HP9836 and i could boot from
the 9122 without any problems. If i remember correctly, you have to specify
a specific HP-IB address for the 9122 (i found that in one of the manuals,
unfortunately i don't have that at hand at the moment ...)
OK, when I get the machine out again (which, as I said last night, won't
be for several months), I'll give it a go. IIRC, the HP drives only let
you set addresses 0 to 7, so it's not a big job to try them all.
-tony