8 Nov
2006
8 Nov
'06
12:11 a.m.
--------------Original Message:
From: Roger Merchberger <zmerch-cctalk at 30below.com>
Subject: Re: New monitors on old machines
my X10 setup won't work thru the ol'
knob-n-tube (already tested
that) installed in my house -- depending on which circuit's going thru
which fuse. However, I've been slowly rewireing the place where I can -
specifically so I can use the X10 modules I have.
I doubt that the knob-n-tube is the problem; have run X10 stuff 100%
reliably in my ancient 3-story knob & tube house for a decade (except
for the occasional module failure).
The RF stuff is another story however...
Have you tried the .1 uf phase coupling cap (or the "official" phase
coupler)?
> 2) train your dog how to work a light switch
He died a few months ago. :-(
Sorry to hear it; so did my cat... :-(
> 3) switch with delay
Hadn't thought of that... might have to check the
lighting shops here to
see what they have in stock...
While you're there, look for a wall switch with IR sensor & delay; sounds
perfect for your app, although you might have trouble finding one that'll work
in your 3-way setup (if you'd still need it).
7) Three way switch at the other enough of the hall.
It's already on a three-way switch with the bottom
of the stairs... do they
make 4-way switches?
Yes, but that'd require additional wiring.
And everyone forgot #8: Win a home remodeling contest
so I can get $100,000
so I can afford to pay someone *else* to gut & redo the house in an
expedient manner. ;-)
Can't beat that!
m