25 Mar
2012
25 Mar
'12
3:01 p.m.
However, VMS is only recognising one of the two drives in the RX50. Apart
from any possible faults in the drive, cable, distribution board etc, is
there
any config needed on the drive itself, bearing in mind
that this is in a
BA123
with an M9058 distribution board?
I have two hard disks in the machine, which are being recognised as DUA0
and DUA1, I have DUA2 as one of the RX50s (the one on the right when it
oriented vertically, it would be the bottom one if it was horizontal), but
no
DUA3.
There is some confusing wording in the RQDX3 docs which suggests the
drives are numbered automatically by the M9058, but then it says to be
careful with the config in the drive to avoid conflicts.
I resolved the problem of VMS only seeing one RX50. I had plugged one of the
hard disks into the connector on the upper half of the distribution board.
This seemed to conflict with the RX50, connecting the two hard disk to the
connectors furthest from the RX50 connector resolved it.
Regards
Rob