1 Dec
2005
1 Dec
'05
6:53 p.m.
Adrian Graham wrote:
The 9600s we look after are all SCSI but you could
swap out
the SCSI modules for others IIRC. The SCSI module will say
what it is if you open the drive up and check the card cage
in the back.
The interface board in mine is Kennedy #7113, Rev D. It doesn't say
anything about SCSI that I can find, but then it doesn't mention Pertec
either :-) It also has a nice little blue tag that says "Tests Good,
8/29/93" :-)
It does have two 50 pin edge card connectors labeled J1 and J2 - certainly
looks like Pertec to me. By coincidence SCSI is also 50 pins, but it
doesn't normally use a card edge connector.
I think we've got the service guide; I can ask the
lads that
look after them.
Thanks - I'd appreciate it.
Bob