17 Jan
2021
17 Jan
'21
11:12 a.m.
On Sun, 17 Jan 2021, Paul Koning via cctalk wrote:
2. RD50s are odd; they use pin 32, which is normally
drive select 4, as
an output to indicate "I am an RD50". The software looks for that
signal. So to emulate an RD50, install the jumper for drive select 4
(alongside the one for drive select 1) on P7.
Unimportant NIT:
On most drives, pin 32 is side select.
On TRS80 [Model 1], which had single sided drives, pin 32 was the fourth
drive select. (10, 12, 14, 32) The cable connectors had missing pins for
three of those four, and the drive was jumpered to respond to all four.
Using four drives AND adding double sided support required some
modifications.
But, on most machines after that, pin 32 is SIDE SELECT. It is used to
access side B of the drive.
On some drives, pin 34 was "DRIVE READY"/"DISK CHANGE"
--
Grumpy Ol' Fred cisin at xenosoft.com