31 May
2006
31 May
'06
3:41 p.m.
On 5/31/2006 at 3:13 PM Al Kossow wrote:
Actually.. it turned out I found some flat heads this
afternoon at
Halted that work, and don't extend much beyond the dimple that I've
pushed into service.
I was about to suggest that you use some truss-heads and file the top a
bit. I've seen cheese-head Torx screws a lot, but the head sounds as if
it's way too thick.
As I mentioned, I've got a bunch of type-T screws that are probably very
close, but they have the three "dimples" on the top for drive.
Good that you found something would work.
Cheers,
Chuck