R: How to save two Mitsubishi M2896 drive (spindle motor smoked!)

I tried to connect a resistor of 10kohm to 3rd wire of the connector but putting it to ground or to +5vdc nothing happens. I also checked if with a disk inserted into the drive what kind of signal come out from the 3rd wire oscilloscope signals on chips of the spindle motor all seems very stop and static. I report below some value of voltages misured on the IC's pin and photos at high resolution at the link below. https://www.dropbox.com/sh/ozy5mn06hyz9jn1/AADelz2vVsTSEAwmwoVzvwppa?dl=0 LB1620 Pin1= 18,2V Pin2= 9,2V Pin3=0V Pin4=24v Pin5=pin6=pin7=0V Pin8=0V Pin9=pin19=8,93V TC9142P pin1= pin5= Q101Base=3,52v pin4= pin10= pin16=8,93v pin6=6,2v pin7=pin8=3,5v pin9= NC =3,52v pin11= Q101collector = 8,97v pin12= pin13= NC pin14= pin15= square wave C358C pin1=pin2=pin3= 4,5v pin4=GND pin5=0,5v connected to the 3rd input wire pin6= 1,2v connected to the r101 - r105 with the other side of r101 connected to pin 16 of 9142 pin7= 7,76v connected to Q101 collector pin8= 9v main link with other info https://www.dropbox.com/sh/p12w71v69tjgfz7/AAAIReql4Se5ZCkLClPoAVOPa?dl=0 Thanks in advance for your help. Enrico