23 Apr
2007
23 Apr
'07
11:53 p.m.
-----Original Message-----
From: cctalk-bounces at classiccmp.org
[mailto:cctalk-bounces at classiccmp.org] On Behalf Of Brad Parker
Sent: maandag 23 april 2007 19:20
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: KY11 - ever debug one?
[...snip...]
Also, my read of the KY11B docs say that I should not have J2
& J3 connected unless I'm in maint mode. (so pulling RDY high
should be fine)
Should the KY11 work (as the docs say) with only J1
connected? Anything obvious I am missing?
-brad
Yes, the 11/34 boots RT11 and runs fine, J2 and J3 disconnected.
And since I must enter 165020 LAD START to startup the diagnostic
code in the PROM on the M9312, I can tell that the console is also
working fine while J2 and J3 are disconnected.
I have J2 and J3 normally always connected, and never had problems.
- Henk.
This message and attachment(s) are intended solely for use by the addressee and may
contain information that is privileged, confidential or otherwise exempt from disclosure
under applicable law.
If you are not the intended recipient or agent thereof responsible for delivering this
message to the intended recipient, you are hereby notified that any dissemination,
distribution or copying of this communication is strictly prohibited.
If you have received this communication in error, please notify the sender immediately by
telephone and with a 'reply' message.
Thank you for your co-operation.