28 Mar
2006
28 Mar
'06
8:26 p.m.
It was written....
DL11-W prints and user manual are on bitsavers I
believe:
http://www.bitsavers.org/pdf/dec/unibus/EK-DL11W-OP-001_May77.pdf
http://www.bitsavers.org/pdf/dec/unibus/MP00106_DL11-W_Aug77.pdf
How did I miss that?? I've been all over that specific page the past week :\
Also, try running the DL11-W diagnostic from the
XXDPv2.5 disk. It is
ZDLDI0 (see diag hnbk p 2.34)
It will tell you if your DL11-W interrupts are working or not.
I said many posts
ago... it fails with "bit 7 fails to set" in reference to
the test of the LTC (with regards to the above diagnostic). Of course,
without diagnostic source I have no clue if the LTC test is before or after
the full serial port test, or maybe inbetween it... But that is as far as it
gets and the message I get.
Jay West