CDP1861 PIXIE graphics chip replacement for COSMAC Elf

In development. Inspired by the Spare Time Gizmos STG1861, but not based on that design. Rev. 0, not yet ready for production: https://www.flickr.com/photos/22368471 at N04/sets/72157667299828132 It is 2.0 inch by 0.7 inch, with a 24-pin round-pin DIP header to plug into a normal 24-pin DIP socket (vs. more the common square pins that won't work with normal IC sockets). The surface-mount components were assembled onto the board by a commercial service, which does not do through-hole, so I had to solder the DIP header by hand. I had to make the pads for the DIP header very small to squeeze the TQFP CPLD between the rows, so it turns out to be unsuitable for hand assembly by novices. Since I am not willing to do the hand assembly for other people, I'm not sure whether this board would actually be worth selling; I might have too many customers that aren't able to assemble it successfully. The CPLD programming is done by a "Tag Connect", which uses pogo pins to contact the ten gold pads seen on the top of the board. There are holes near those pads for the Tag Connect's steel alignment pins; while there is enough clearance on the top of the board, I failed to consider that the frame of the DIP header on the bottom of the board would prevent two of the alignment pins from extending far enough. I had to cut out part of the DIP header frame. The CPLD code has been written but has not yet been debugged.