7 Jun
2002
7 Jun
'02
1:04 a.m.
Loboyko Steve wrote:
I'm building a 6800 machine right now and I was
wondering about this "Halt and Catch on Fire"
instruction. Is this for real. This is a serious
question. Is there actually an instruction that will
overheat the chip?
Not on the 6800 but I believe some FORTH chips have that problem.
This instruction for the 6800 if remember right just continually
increments the address bus, ignoring any data read. Only a hard
RESET will reset the machine from this state. I think the opcode
is $00.