5 Jan
2005
5 Jan
'05
3:50 p.m.
----- Original Message -----
From: "Vintage Computer Festival" <vcf(a)siconic.com>
To: "General Discussion: On-Topic and Off-Topic Posts"
<cctalk(a)classiccmp.org>
Sent: Wednesday, January 05, 2005 11:43 PM
Subject: Re: Importing binary files without removable storage nor
non-bundled software (was: TKermitFTP
On Wed, 5 Jan 2005, Patrick Finnegan wrote:
Programmers did have a work around. The answer for decades has been hex.
Many times I transfered software to both DOS and CP/M by using hex files.
Randy
www.s100-manuals.com
Vintage Computer Festival declared on Wednesday
05 January 2005 11:19 pm:
And the programmers were not smart enough to figure a way around this
because...why?
--
Sellam Ismail Vintage Computer
Festival
------------------------------------------------------------------------------
International Man of Intrigue and Danger
http://www.vintage.org
[ Old computing resources for business || Buy/Sell/Trade Vintage
mputers ]
[ and academia at www.VintageTech.com || at
http://marketplace.vintage.org ] On Wed, 5 Jan 2005, Pete Turnbull wrote:
Well, my guess would be that it has no way to determine the EOF coming
over the line, as it can't just "check the file length", unless
there's
a ^Z there to indicate it. Thus, ASCII mode is needed. Dunno, I don't have quite such old versions
:-) My old copy of "The
MS-DOS Bible" says "every version" -- it means 3.30 and older --
disallows binary reads from devices. The same message is at 5254 in
MS-DOS 3.30 (ditto in PC-DOS 3.30), at 4CA0 in 3.21, and 4CCC in
IBM-DOS 4.01 (from a Compaq). I can't read my MS-DOS 2.10 and 2.11
disks on the hardware I have here. "Binary reads from a device are
not allowed" is the message at 8753 in DR-DOS 3.41.
The question I haven't seen answered yet is, "Well, why the hell
not???"