Looking for RL02 cable and terminator

I have an RL02 cable that goes from the controller to the drive. That was commonly used in "package" situations where you had things like a 8/A or 11/23PLUS in a H96xx chassis shipped from the factory. Unfortunately on this cable the part that screws onto the drive has broken off, but I used to use that cable and it never affected anything, it works great. I ran a single RL02 with RT-11 on it for a long time, and played many games without problems. I also have a spare terminator. Let me know if you want it and maybe we can work out a trade or something. Julian -----Original Message----- From: cctalk-bounces at classiccmp.org [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Charles Sent: Saturday, October 15, 2005 10:47 PM To: cctalk at classiccmp.org Subject: Looking for RL02 cable and terminator ... like the subject line says. Now that my 8/A is up and running it's time to hook up the RL02. I do have the interface board plugged into the Omnibus, the correct boot ROMs on the option board, and the RL02 has the Unit "0" plug but no cable or terminator. I could make my own if someone can tell me where to get the connectors that fit the drive end. Also, I think someone cannibalized the disk brush out of mine :( There is a big open area towards the right rear of the disk compartment and a pin with a snapring groove protruding downwards, but nothing in the empty hole there except two silver-colored tubes down below (air ducts?)... seemed pretty clean inside, as it should. So I left the heads parked (blocked by the transport plate), inserted the disk pack and ran the blower for a while anyway. Fault light was on, load light was not. I didn't hook it up to the interface board (obviously :) but not being well-acquainted with these drives I don't know if it *has* to be connected before the fault light goes off, or the heads free to load, or both... I do have a copy of the "RL01/02 Disk Subsystem User's Manual" but the service manual and parts list looks essential at this point. Hope it's on bitsavers ;) Thanks for any help. -Charles