15 Jun
2010
15 Jun
'10
4:03 p.m.
I have a Vector Graphic's ZCB cable that is wired for a 9600b 8/n/1 serial
terminal. It was working yesterday, but the connections were brittle and a
few of the wires have come loose from the 25-pin connector. I can see the
spots where the solder was applied but I am not confident that I have the
correct repair points. Does anyone have the pinouts for this cable so I
can re-solder/replace? A picture says a 1K words. I am not sure I have an
original cable. I will keep looking and if I find the answer I will post
it here.
Thanks
Bill