29 May
2016
29 May
'16
noon
On 5/29/16 11:34 AM, Mark J. Blair wrote:
My first attempt to use silicone tubing to repair my
TU58 rollers was also unsuccessful. Maybe the material I used is too soft? Your experience
suggests to me that I should hook up an oscilloscope to measure bit timing, and then
adjust the roller composition and diameter to arrive close to the correct bit length.
dug this up from the cctlk archive
--
http://www.usplastic.com/catalog/item.aspx?itemid=23485
It just says "norprene A-60-F" the outside. It measures 3/8" I.D.
I think other's have said 7/16" i.d., but I could not find that. I know I bought
it from US Plastics and it's A-60-F.
You have to buy 10' but its not very expensive.
-brad