10 Feb
2011
10 Feb
'11
12:33 p.m.
Ah, I,ve figured out how to remove this motor board now. The clip-looking
piece of metal at the front is indeed a clip and once the screws are undone
Ah, so it clips under the chassis too... Was there any heat-sink compound
(white gunge) between them>
you can unclip the clip from the casing so that the
whole lot, clip,board
and motor comes up all as one unit (I should take photos of this for others
who might have to take these apart).
The clip is attached (soldered over) two of the outer pins of the suspected
TA 7259 (assuming I'm on the right track). If I can desolder the clip (so I
I would assume it's soldered to the tabs,
If so, you don't need to link them together, they are internallty linked
inside the chip.
-tony