On Wed, 14 Jun 2000, Cameron Kaiser wrote:
Despite the fact that every term program under the sun
seems to support
Tek 4014/5, I cannot find a description of the control sequences anywhere
(just a reference to the termcap entry, but I want the *graphics* control
sequences, not the terminal ones). Does anyone know where I might find a
listing of them?
Yes. :-) I just dug up my Tektronix 4114 Display Terminal Operator's
Manual and found the following beginning on page C-4: List of Escape
Sequences; each escape sequence is listed alongside it's corresponding
command and setup command. For example:
Ec(I)(A)<int> Set-GIN-Cursor None
.
.
.
Ec(L)(X)<xy> Set-Dialog-Area-Position DAPOSITION
Is that what you're looking for? If so, e-mail me your snail-mail
address and I'll send you photocopies of these escape sequences.
BTW, Does anyone on this list have, or know where I can obtain,
service data for my Tektronix model 4014 terminal?
--
R. D. Davis
rdd(a)perqlogic.com
http://www.perqlogic.com/rdd
410-744-4900