6 Nov
2004
6 Nov
'04
8:54 a.m.
Hi Guys,
I have an Osborne-1 with a bad monitor - I have the technical
manual, which gives schematics for the main logic board and
the disk board, but NOT the monitor.
The monitor is a: Zenith model DS5NF3
I don't recognise the number, but maybe the IBM Portable PC monitor is
similar in design (it is a Zenith chassis)
Symptoms are:
Its Powered through a single +12v line on the connector,
filiment lights, which suggests power is present.
I would guess this CRT has a 12V (or close) heater (most 7 pin ones do) that
runs directly off the power input line (maybe through a resistor, but
nothing more).
Horizontal drive, vertical drive and video signals are all
present on the monitor connector.
No light at all, no "buzz" typical of flyback transformer.
Looks like horizontal/high-voltage circuit is dead.
Unfortunately I have no schematic - At least the only IC on
the board is a 555 - hopefully no unobtainium used in this
one (unless it's the flyback :-(
I would start by tracing the horizontal drive signal. My guess (without
seeing it) is that the 555 is part of the vertical circuit and can be
ignored for the moment. You may find the horizontal drive signal goes to
the base of the drive transsitor, transformer coupled to the base of the
horizontal output transistor, thence to the flyback.
I ahve had the horizontal drive transformer go open-circuit in a Zenith
monitor. It's not hard to rewind, though.
anyone got diagrams or other service information on a
"Zenith DS5NF3" monitor.
Suggestions/debug hints welcome - I'm guessing horizontal
output transistor or flyback ...
You should be able to trst the former fairly easily. Of course if it's
failed, there may well be other problems that killed it.
-tony