19 Feb
2017
19 Feb
'17
3:42 a.m.
On 18.02.2017 04:07, Jay Jaeger wrote:
On 2/17/2017 10:01 AM, Philipp Hachtmann wrote:
No. I already decided to do them. It's just the details.
On 02/17/2017 01:02 AM, Jay Jaeger wrote:
The thanks was for your effort. The hope that it works out was to say
that I hope that you decide to make some more and sell them, which seems
uncertain at this point. First of all THANKS. I hope this works out.
?!?
That was why I specifically wrote *shield*. There are
a lot of SPI
interface boards out there, and if there were a little room in the chip
to handle an Omnibus/SPI interface, a lot could conceivably be done with
it. Examples: SD Cards, Ethernet and so on.
With an FPGA I even would have
considered soldering an ether net PHY
onto the board..
As others have since pointed out, KiCAD has nothing
whatsoever to do
with Arduino. Others have addressed its strengths and weaknesses. In
my case, the comment stemmed from perhaps wanting to take you hardware
design, and adapt it for other purposes, without having to start from
scratch.
Haha :-)