So I have a TU81+ and a KLESI-UA that I'd like to hook up to my 11/44. My
first stop was bitsavers and google, to see if there was any specific docs
on these. I found docs on the TU81+, but the only thing I found on the M8739
is the printset.
1) Can't find anything detailed about all the dip switch and jumper settings
on the KLESI
2) The printset seems to be for a slightly different board than mine (mine
has J1 vertical, printset shows it horizontal)
From what I read in the TU81+ docs, it seems that it
should pass built-in
diags without the need for a host connection. Upon powerup,
after a moment I
get Ebb in the display. Can't seem to find what that refers to. Reset button
does clear it though.
Running diag 01 consistently fails after about 4 minutes with "E06". I
cleaned the heads, tape cleaner, rollers, and am using a brand new tape.
Same results. Test 60, 58, and 59 all end with "00" in the display, but the
fault light comes on. 00 supposedly indicates a passed result, but the
writeup on the test doesn't mention if the fault light is indicative of a
specific result.
Apparently my RT-11 docs are old... what is the device driver code for
TU81+?
Any pointers or advice is most appreciated!
Jay West