Four-phase non-overlapping clock generator using PIC microcontroller

In the 1970s, some microprocessors and support chips used four-phase NMOS logic. Some, including the Rockwell PPS-4 and PPS-8, generated the four non-overlapping clock phases on-chip based on two external clock inputs, while others, including the TI TMS9900, the Western Digital CP1600 chip set (used in DEC LSI-11 and Alpha Micro AM100), and the WD9000 chipset (used in Pascal Microengine), required an external four-phase clock generator. Typically the four-phase clock inputs required a voltage swing close to the Vss and Vdd supply rails (0 to +12V). TI and Western Digital offered support chips to generate the four-phase clock, although it was often done with a crystal, 74S logic, and MOS drivers such as the National Semiconductor MH0026 dual MOS driver or the Intel 3245 quad MOS driver. I've recently had occasion to work on interfacing to some of these old chips, and wanted a modern four-phase clock generator. I've just written and tested code to use a Microchip PIC16F1575 as a clock generator, though it only has 5V outputs, so it will require external gate drivers, such as a Microchip TC4469 quad gate driver, to obtain the 12V swing. The PIC16F1575 is a fairly new part using Microchip's enhanced midrange core. It is in a 14-pin package, has an internal oscillator, PLL, and four 16-bit PWM modules. The PWM modules can operate independently, but for this purpose it was convenient that they can be synchronized. I've configured the PIC to use the 8 MHz internal oscillator, with a 4x PLL for a 32 MHz clock going into the processor and the PWM modules. The CPU speed doesn't matter, but that gives timing resolution of around 31ns for the PWM. I've configured the PWMs for a period of 16 clock cycles (500 ns, 2 MHz), clock high pulses of three clock cycles (93ns), and delay between phases of one clock cycle (31ns). This could be trivially changed to a 2.67 MHz clock by reducing the period to 12 cycles and hte clock high pulses to two clock cycles (62ns). Either set of timings is within the specifications of the TI and Western Digital parts. A word of caution: when using gate drivers to drive old NMOS parts, I recommend the use of series resistors of at least 10 ohms and schottky diode clamps to Vss and Vdd, to ensure that undershoot and overshoot (due to ringing) are limited to 0.3V. The C source code is released under the GPLv3 license on github: https://github.com/brouhaha/4phaseclk