On 02/02/2018 03:13 PM, Fred Cisin via cctalk wrote:
they might
have different ground systems. If so, grounding both ends
might produce a LARGE current through the cable, possibly enough to be
hazardous.
OB_Ignorant_Question:? Is that the reason why RS232 DB25 has both pin 1
and pin 7?
I don't think so--pin 1 is basically a "protective ground", where pin 7
is a "signal ground".
Consider an ordinary telco subscriber line. 2 wires, but there's also
some sort of carbon block surge arrestor connected to an earthed ground
at the subscriber's site. It may be connected to the AC protective
ground (i.e. third prong in an outlet) or it may be separate.
In my home, it was a wire attached to a copper rod driven into the
earth. After a tree was uprooted and the cable unearthed, I notified my
telco about it, was issued a service ticket--and nothing happened. I
coiled up the ground wire neatly and buried it. It probably doesn't
matter because my telephone line is buried its entire length back to the RT.
It used to be that this wire was connected to the finger stop on old
dial telephones.
In any case, it isn't a signal conductor.
--Chuck