Emulex TC12 controller

Hi Guy, perhaps I can be of some help here. I've got the original Emulex documentation of the TC12 tape coupler, and also the TC02 tape coupler. Both boards are quad-sized, the TC12 is for UNIBUS, the TC02 is for QBUS systems. To identify if your board is a TC12, I describe what is in manual. (wished that those pictures were in more manuals, they're great!) With the four rows of finger contacts right before you, in the middle of the board, at the left of the center are two DIP switch packages, and to the left of those are first 2 small IC's followed by 2 big AMD 2901 bit slices. At the opposite of the 4 finger contact rows (which go into UNIBUS slot positions C,D,E,F) are two 50-pin BERG header connectors. If this manual seems to be what you are looking for I can scan it at 600 dpi. Big file, but when printed gives very good copies! The contents (briefly): Introduction - General Description - Functional Description - Packet Processing - Installation - TC12 Option Switches - Address Selection - Autoconfigure and VMS, RSTS/E and RSX-11M. See mainecoon for an impression of the scan quality -- they are my work. - Henk, PA8PDP. -----Original Message----- From: cctalk-bounces(a)classiccmp.org To: General Discussion: On-Topic Posts Only Cc: cctalk(a)classiccmp.org Sent: 11-10-2004 6:07 Subject: Emulex TC12 controller Hi, I'm looking for information on the Emulex TC12 (I'm assuming) tape unibus controller. I have two Kennedy 9300 drives that I'd like to hook up and I have an Emulex TC12. I also have an AVIV board (hex height with 2 50 pin connectors on the top) that I have no other information on. Any help would be appreciated. Thanks. -- TTFN - Guy