29 Feb
2004
29 Feb
'04
11:12 a.m.
On Feb 27, 2004, at 11:03 PM, Tony Duell wrote:
Hopefully under heavy sedation?
No, actually you want to be fully allert so you don't lift any traces on
the PCB.
It's not _that_ bad a job. I've had to do it a number of times, and I
don't worry about it any more.
-tony
Tony....
It's not _that_ hard to replace. The trick, of course, is to cut the
male
connector apart while it's still soldered to the PCB, and desolder it a
bit at a time. >> I would suspect that ... it's the
female part that wears out.
>> the male part ... not likely to show much wear
While this may be true, it is usually a bad experience when the male
part
gets severely bent or broken.......