DEC H7260 PSU fault

Hi all, I mentioned this in the thread where I'd asked about basic Microvax II info, but it may have got lost in traffic... The machine's H7260 PSU is somewhat unwell - one of the internal +5/12V supplies appears to be healthy, but the other has outputs which are sitting at around 2.5V (both on the 5V and 12V rails) under a test load. Initial questions... 1) Are schematics are available online? I couldn't find them (either under the DEC p/n or the Astec AA13010 one), but perhaps they're buried in schematics for a specific DEC machine somewhere. 2) Upon initial glance, the 'first' board of the three in the PSU module appears to be a pair of control relays, bridge rectifiers and capacitors, supplying +/- DC voltages to the two individual PSU boards. Does anyone know if I can disconnect these from the PSU boards safely* and measure their outputs, and if so what voltages I should expect to see? That might be a good initial test before pointing a finger at the PSU board associated with the low outputs. * I mean without component damage - I expect they might be sitting at a significant DC voltage, so there's an obvious personal safety aspect too ;-) cheers Jules