Free stuff (UK) again

I had a more careful look at the pile of terminal servers and hubs today, and found some more "stuff". I'm surprised I've had so little response, but if anyone definitely wants any of this, please let me know before the end of next week or it will be gone (crushed/landfill). However, if I know for sure that someone wants particular things, I can hold some of them for a little longer. qty.1 VT220, amber screen, working, in resonable condition, with keyboard qty.1 VT510, green (I think) screen, decent condition, with keyboard (There may be a few more VT510s or VT420s. Apparently someone found four in a storeroom this morning, but I've not inspected them yet.) qty.15 Emulex P4000 terminal servers, 32-port, network booting (DECnet or TCP/IP), with parallel port, BNC connector, AUI connector, and 32 MMJ ports. I'll throw in 32 short MMJ-to-RJ45 cables and an Allied Telesyn 10baseT microtransceiver with each. 1 is working (well, it powers up and passes the self-test); 5 are "faulty" (power light comes on but not much else happens -- probably faulty PSU), 3 are "dead" (almost certainly blown PSU), 4 have no PSU board, and there are two that I've not properly tested yet. qty.6 32-port 19" rackmount panels, 2U high, to take clip-in jacks (eg RJ45 couplers). Sorry, no spare RJ45 couplers. These were used with the terminal servers, we used short MMJ-RJ45 cables to connect the TS to the back of the panel, and connected normal patch leads to the front. You can buy couplers (but be warned, I've never yet seen one that met the Cat5 spec, despite some claims), or individual clip-in RJ45 sockets with Krone/110 punchdown connectors (which do meet Cat5/5e/6 specs) in various colours, BNC connectors, ST fibre connectors, etc. qty.?? several (a dozen or so) 3Com Linkbuilder FMS II 24-port hubs, 1U high 19" rackmount, mostly with management units. Good for the PSUs if you don't need a 10Mb/s hub :-) qty.?? several (a dozen or so) 3Com SuperStack II PS 40 24-port hubs, 1U high 19" rackmount, with on-board management. Neater than the FMS II hubs. Various expansion modules that plug into the back of 3Com hubs. You can fit two to a PS 40, or one to an FMS II: qty.10 AUI port, 10base5 module qty.1 BNC 10base2 module qty.5 Fanout module, like an AUI in reverse qty.1 AUI bridge -- looks like an AUI port but has a lot of electronics too qty.6 (or maybe more) fibre optic adaptor with 2 x ST connectors Also a box of Allied Telesyn AUI-to-10baseT microtransceivers, and several older (mostly 12-port) hubs that are good for the PSUs (and not much else IMHO). I'll be away from tomorrow night until Wednesday, but if you want any of this stuff, please email me. It seems a shame to scrap it completely. -- Pete Peter Turnbull Network Manager University of York