MicroVAX 3100 update

Hi, OK, so the MicroVAX is *still* not responding... I've at least ruled the power supply and the terminal and the terminal cables out however. I put the power supply from the functional VAXstation 3100 in the MicroVAX, hooked up the Wyse 50 I use with the VAXstation along with its DECConnect cable to the MicroVAX (BTW; I used the MicroVAX's manual to set up the VAXstation, therefore the cable must be plugged in properly), and turned the critter on... same results as before.. The console says "_~" and that is about it.. The manual talked about that possibly indicating a disk drive problem, but I tried it both with and without hard disk.. no dice. Any further ideas? Also, I'm going to be finally updating my website with *far* more Interdata/Perkin-Elmer/Concurrent info than anyone could possibly want, along with the same scope of Nova 1210 info, including the sheet on how to modify an ASR-33 with the DGC teletype interface board. Will J ______________________________________________________ Get Your Private, Free Email at http://www.hotmail.com