10 Jun
2005
10 Jun
'05
1:56 p.m.
Subject: S100 PROM boards
From: "Cini, Richard" <Richard.Cini at wachovia.com>
Date: Fri, 10 Jun 2005 16:09:44 -0400
To: "'General Discussion: On-Topic and Off-Topic Posts'"
<cctalk at classiccmp.org>
All:
With my two new machines I want to get a PROM monitor in them so
I can start really playing around with them. I have a single Vector RAM/PROM
III board, which uses 2704 or 2708 EPROMS. Most of the chips I have are 2732
or larger.
Before I go slogging through the manual to try to hammer a 4k
chip into a 1k socket, does anyone have any experience making this mod?
Alternatively, can someone recommend a good general PROM board that can use
larger EPROMS (programming feature not necessary).
I'd build a board, it's fairly trivial. Compared to the mods needed to
make a 2708 board take 2732s. There is one easy way and thats to make
a header that takes the 2732 and maps the Data/Address/CS-/OE- pins
to the 2708 socket along with power and ground. That will allow only
using 1k of the 2732 but that may be all you need. the upside is one
2732 can hole 4 1k programs and it's easier to program than 2708.
Allison