VERY LONG: Latest S-100 Haul

Hello all, Thanks to a VERY generous man, located about an hour's drive from me, I have a boatload of CompuPro S-100 stuff, 8" floppy drives, manuals, software, etc. The list is long, and I debated posting it here, or linking to a web page. In the end, I decided to post it here because I wanted it to be in the archives in case anyone was looking for any of this stuff. I am more than willing to copy floppies or manuals, no charge but postage (and you supply the 8" media, as I am VERY short of blanks). The only caveat is that it may take me a long time to do it, mainly becuase I'm not very organized :-) Before the list, there were also two Osborne 1 computers, one with a dead internal monitor (but works from external monitor), and one fully functional, with the double-density upgrade. Also, manuals and full sets of original disks for each. Without further ado, here's the list: CompuPro chassis, 21-slot motherboard - 1 Full CompuPro RAM22 board - 1 Full CompuPro RAM22 board - 1 Full CompuPro RAM21 board - 1 Full CompuPro RAM16 board - 1 Full CompuPro RAM17 board - 1 Macrotech Dual Processor board -- 80286 and Z80H - 1 CompuPro System Support 1 - 1 CompuPro DISK3 Hard Drive controller - 1 CompuPro Interfacer 4 - 1 CompuPro DISK1A Floppy Drive Controller CompuPro System 8/16 Chassis, 20-slot motherboard - 1 Full CompuPro RAM22 board - 1 CompuPro MDRIVE/H 512K/2 MEG disk emulator board - 1 CompuPro CPU68K board - 1 CompuPro System Support 1 board - 1 CompuPro Interfacer 4 board - 1 CompuPro DISK1 Floppy Controller Board Three dual 8" drive units (one CompuPro, two no-name) -- The CompuPro unit has two QumeTrak drives (242, I think -- full height 8"), one of the no-names has two Shugart 801 drives (single-sided only, I think), and the other no-name also has two QumeTrak drives. Unfortunately, the power supply in the no-name QumeTrak drive box literally had an LM723CN explode, breaking the chip in half, melting the socket, and fusing two pins to the socket. Cheap enough for a new chip, but time to put in a new socket, and figure out if something else has gone bad... One dual 5.25" floppy and 5.25" 40MB hard drive unit Additional S-100 cards: - Mullen Computer Products bus tracer board - CompuPro Interfacer 4 w/cable - Solid State Music PB1 2708/2716 EPROM Programmer - CompuPro DISK1 Floppy Controller - Jade Double D Floppy Disk Controller - Quantronics MM8 8K memory board, 64 2102 chips - Performics 256KB RAM card - CompuPro CPU-Z - Jade JG-Z80 Rev. C CPU board (Z80A) - Qty. 2 CompuPro CPU 8085/88 - Ackerman Digital Systems PROMBlaster II - Franklin Electric I/O Interface - Vector Electronics Interfacer II - Jade Parallel Serial I/O Board - Data Technology Corporation DTC 10-1 - Tarbell Cassette Interface, Rev. D Model 1001 - CompuPro System Support I - CompuPro RAM17 - ExpandoRAM Rev. E Original Software, 8" Floppies - CompuPro CP/M 8-16, version 1.1R - CompuPro CDOS 8-16, 4.1D-2, also labelled by CCT, version 2.0b - CompuPro DR Net, version 1.1A - CompuPro AMCALL/TIP Master, version 2.68/2.40 - CompuPro CP/M-80, version 2.2N - CompuPro CP/M-80, version 2.2LD - CompuPro CP/M-80, MDRIVE System Master, version 2.2LM - CompuPro CP/M-86, version 1.1PA - Jade CP/M version 2.2, for Double D controller card - CP/M-68K, version 1.0, labelled by Westico Software Express Service - SuperSoft C compiler (no version, copyright 1981) - CompuPro Assembler and tools 86 version 1.0 - CompuPro CP/M-68K version 1.1 - Digital Research C compiler for CP/M-86, version 1.11 - Term 3 by Echelon - Z-COM by Echelon - Discat by Echelon - PKey and I/O Recorder by Echelon - B/Printer by Echelon 20-30 Blank 8" media, some 1-sided, some 2-sided Manuals (* = original, no * = photocopy) - Code Works Small C for CP/M version n, April 1, 1981 * - BDS C version 1.4 - Jade Double D Software Manual - IMSAI 8080 Self-Contained System Operating System -- User manual and source code listings - Processor Technology Software Package #1 source listing - Qty. 3 CompuPro Interfacer 4 * (w/ schematic) - Digital Research CP/M 2 docs * - BDS C Version 1.5 * - ADS Promblaster II / Promwriter 4.0 * (w/ schematic) - CompuPro CP/M 68K Technical Manual and Installation Procedures * - Qty. 3 CompuPro RAM22 Technical Manual (w/ schematic) * - CompuPro System Enclosure and Motherboards Technical Manual * (w/ stickers and schematics) - Qty. 2 CompuPro DISK1 Technical Manual w/ schematics * - Qty. 2 CompuPro System Support 1 User Manual * (w/ schematics) - ViaSyn MDrive/H Technical Manual * (w/ schematics) - CCT Brochures, Price Lists - 4 issues of C-Pro newsletter, volume 2, issues 1-4, 1985 * - Tarbell BASIC I/O System - cassette version, version 12.12 listing - Tarbell Cassette BASIC, version 12.14 listing - CompuPro System 816A Standard Switch Settings and Cable Connections - CompuPro CP/M-80 2.2 Technical Manual and Installation Procedures - Digital Research CP/M-86 Release Notes, version 1.1 * - CompuPro System Support 1 Technical Manual * (w/ schematics) - CompuPro CPU-Z User Manual * (w/ schematics) - Qty. 2 ViaSyn/CompuPro CPU 8085/88 Technical Manual * (w/ schematics) - Qty. 2 CompuPro RAM17 Technical Manual * (w/ schematics) - CompuPro DISK1A Technical Manual * (w/ schematics) - CompuPro System 8/16 Enclosure and Motherboards Technical Manual * (w/ schematics) - CompuPro Concurrent DOS 8-16 Installation and Customization Guide * (marked "Advance Copy") - CCT Concurrent DOS 8-16 CMX XIOS User Guide * - Macrotech MI-286 Dual Processor (80286/Z80H) Reference Manual * (w/ schematics) - Vector Electronic Interfacer II Technical Manual * (w/ schematics) - CompuPro FORTH Technical Manual * - Performics SRAM 128/258 User's Manual * (w/ schematics) - CompuPro CPU-68K Technical Manual * (w/ schematics) - CompuPro RAM16 Technical Manual * (w/schematics) - CompuPro RAM21 Technical Manual * (w/ schematics) - Franklin Electric I/O Serial Parallel Assembly and Test Instructions * - Data Technology Corp. DTC-10-1 Preliminary Specification (w/ schematics) - CompuPro CP/M 80 2.2 Hard Disk Installation Guide * - CompuPro MDrive Installation Manual * - CompuPro CP/M 8-16 Technical Manual and Installation Procedures * - CompuPro CP/M-86 Technical Manual and Installation Procedures * - QumeTrak 842 8" Floppy Maintenance Manual - Jade Double D Floppy Controller Manual * (w/ schematics) - Qume DataTrack 8 Maintenance Manual - Shugart 800/801 OEM Manual - PSS Model MM8 8K RAM System Manual - Solid State Music PB1 EPROM Programmer Board * (w/ schematcs) - SD Systems ExpandoRAM Operations Manual * (w/ schematics) - Tarbell Cassette Interface (w/ schematics) - Mullen Computer Products TB4 * (w/ schematics) S-100 test/probe board - Jade Serial Parallel Interrupt Controller * (w/ schematics) - Jade "The Big Z" (Z80 CPU board) * (w/ schematcs + monitor) - CompuPro TMXBIOS listings * - CompuPro DISK3 (ST506) Technical Manual * (w/ schematics) - CompuPro AMCALL and MCALL-II (comm prog.) Operations Manual * - CompuPro AMCALL and AMCALLN (supplement to above) * - Qty. 2 CompuPro CP/M 2.2 Technical Manual and Installation Procedures * - Qty. 2 CompuPro CP/M-86 Technical Manual and Installation Procedures * - Soroc IQ120 terminal Specifications and Operating Procedures * - Digital Research/CompuPro CP/M 2.2 User Reference Manual * (1 from 1982, 1 from 1978) - Qty. 2 Digital Research CP/M-86 System Guide * - Qty. 2 Digital Research CP/M-86 User's Guide * - Qty. 2 Digital Research CP/M-86 Programmer's Guide * - CompuPro Concurrent DOS 8-16 User's Guide * - Digital Research Concurrent CP/M User's Guide * - Digital Research Concurrent CP/M System Guide * - Digital Research Concurrent CP/M Programmer's Reference Guide * - Digital Research Concurrent CP/M-86 Programmer's Utilities Guide * - Lattice C Compiler v2.15A For 8086/8088 * - Digital Research DR Assembler Plus Tools for CP/M-86 * - Digital Research C Language for CP/M-86 * - Digital Research CBASIC Compiler for CP/M-68K * - Digital Research CP/M-68K User/System/Programmer Guides * - Digital Research C Compiler guide for CP/M-68K * - Supersoft Version 1.2 C Compiler for CP/M-80 * - DBase II User Manual - DBase II Reference - Microshell 1.2 User Manual - CP/M 2.2 Patches and Application notes from Digital Research - PC-Pro User's Guide - Wordstar 3.0 Customization Notes - Wordstar 3.0 General Information Manual - Wordstar 3.0 Installation Manual - Wordstar 3.0 Reference - Supersort 1.6 Operator's Handbook and Programmer's Guide - Datastar 1.1 User's Guide - CBASIC Version 2 Language Manual - The Zapple Monitor Version 1.1 - Word-Master 1.07 User Manual - SpellGuard User Manual - MAC -- Cal Poly Macro Assembler Manual * - Tarbell BASIC Manual - Calcstar 1.0 User's Manual - BSTAM Version 4.6 User Manual - CB-80 Languare Release Notes, and Reference Manual - Cal Poly/Link-80/RMAC/Library User's Guide - SID User's Guide - Microsoft MBASIC Compiler User's Manual - Microsoft BASIC-80 Reference Manual - Microsoft Utility Software User Manual (MACRO-80/LINK-80/CREF-80/LIB-80) - Island Cybernetics Information Retreival System v2.07 User's Manual - CP/M 3.0 System/Programmer/User Guides - CP/NET User's Guide - MP/M-II System/User/Programmer Guide Non-Original Disks (all 8", mixed 1S/2S, mixed densities) - Concurrent DOS 3.1D - Concurrent DOS 4.1D - CompuPro CP/M 8-16 Implementation Files - CompuPro CP/M 2.2N - Godbout CP/M 8-16 1.1PD - CompuPro CP/M 8-16 1.1R - MP/M-II 2.1 - MP/M-II 8-16 - MP/M Gen - BDS C 1.46 - Datastar - Wordstar - Spellguard - Wizard C 2.1D - Aztec C 3.2 - Lattice C 2.15 - DRI Assembler/Tools for CP/M-86 - 68K Cross-assembler - CB80 1.3 - CBASIC 2.38 - Fortran 80 - Turbo Pascal for CP/M-86 - SuperSort - DBase II - Selector III - Datastar 1.4 - IRS Infomaster - BSTAM (telecomm program) - BDS C 1.45 - Word-Master - Random House Thesaurus - Wordstar-86 - Small C 1.1 - Calcstar 1.2 - Microsoft BASIC v.4.5, 4.51, 5.1, 5.2 - CP/NET Version 1.0 Whew! That's all folks.... Rich B.