27 May
2009
27 May
'09
8:44 p.m.
On Wed, May 27, 2009 at 11:17 PM, bfranchuk at jetnet.ab.ca
<bfranchuk at jetnet.ab.ca> wrote:
Ethan Dicks wrote:
Not something I'm likely to do... I have multiple rolls of 2-3 sizes
within three armspans.
I just got my VT-6 partial kit today - time for
me to start assembling it!
Just don't run out solder like ?I did ... I got a few caps in and where did
I lose the rest of the roll? Any how I also have to next week pick up a 9 volt DC
wall wart too.
I usually get those from the Thrift Stores near here for $0.90 (along
with car chargers, etc). For this, though, I was planning on using
externally regulated power since I also get +5VDC switchers from the
same source at the same price.
I also have an unassembled PockeTerm. I was thinking of powering both
it and the VT6 _plus_ a 2-port KVM from the same +5VDC supply and
using the KVM for a session switch. ;-)
-ethan