OK, so I dug the Kaypro II back out of storage now that I have some
usable floppy disks, thanks to a good friend. :)
Anyway, I found out that the current A: drive wasn't being detected in
the BIOS on my disk creation machine. B: disk works fine. Checked all
connections and made sure everything was seated properly, and still no
luck. So I pulled both drives and inspected everything and then just
swapped positions and re-installed them, hoping that the different
positions on the cable was what selects which drive is which. Well, not
so. The machine still tries to select the original A: drive. Is there a
jumper setting on these old full bay 5 1/4 floppies to select the drive
ID? Any ideas?
--
Dave Land
Land Computer Service
Check out my site at
http://www.landcomp.net