9 Apr
2003
9 Apr
'03
8:43 a.m.
the lists above but that's the way they're
shown in the 98622 manual. I
have the pin outs of the 98622 but I don't have them for the 9885. At least
I don't have them readily available.
If it's any help. I'll include the wirelist of the cable to link the 9885
to the 98032 GPIO interface (for the HP98x5 machines). That at least
should give the pinout....
The 'wire' column gives the wire colour using the resistor colour code
(base colour, then first stripe, then second stripe). The 'DD50' column
is the connectr on the 9885. Ignore the 'jumpers' section -- that refers
to the configuration jumpers inside the 98032 interface.
DD50 Wire 98032 Signal
1 9 A25 Drain
2 905 A1 Gnd
3 906 B1 Gnd
4 927 A22 Ctl0
5 902 A21 PReset
6 928 A23 Ctl1
7 918 B21 EIR
8 9 A18 Gnd
9 9 B18 Drain
10 98 A19 Pctl
11 903 A24 Gnd
12 904 B24 Gnd
13 8 B19 Pflg
14 908 B20 Psts
15 901 A20 I/O
16 916 B22 Sti0
17 917 B23 Sti1
18 948 A2 DO15
19 947 A3 DO14
20 946 A4 DO13
21 945 A5 DO12
22 937 A6 DO11
23 936 A7 DO10
24 935 A8 DO9
25 934 A9 DO8
26 97 A10 DO7
27 96 A11 DO6
28 95 A12 D05
29 94 A13 DO4
30 93 A14 DO3
31 92 A15 DO2
32 91 A16 DO1
33 90 A17 DO0
34 N/C
35 926 B2 DI15
36 925 B3 DI14
37 924 B4 DI13
38 923 B5 DI12
39 915 B6 DI11
40 914 B7 DI10
41 913 B8 DI9
42 912 B9 DI8
43 7 B10 DI7
44 6 B11 DI6
45 5 B12 DI5
46 4 B13 DI4
47 3 B14 DI3
48 2 B15 DI2
49 1 B16 DI1
50 0 B17 DI0
Jumpers :
2 Output +ve true
7 DMA Enable
8 Clock high input byte on rdy
B Word Input
E Clock low input byte on rdy
F Word Output