5 Feb
2012
5 Feb
'12
8:50 p.m.
On 05/02/2012 16:57, Daniel Snyder wrote:
I have looked high and low it seems for documents that
detail
the pinout of J1 on a KDJ11-B cpu module. The manual I have
shows that J1 is the SLU connection and J2 is for baud rate and
status LED's. I have SLU's for MicroVAX II's and 3800's. Both
of these have the right pin counts but by no means indicates the pinout
is compatible. Pinout diagrams would prevent me from letting out the
magic smoke on my only 11/83 CPU module.
You're very unlikely to let any smoke out by connecting J1 incorrectly.
It's a 10-pin Berg connector and AFAIR is wired exactly the same as
the matching connectors on a KDF11-B, MXV11-A or -B, DLV11-J, etc.
The cable to the proper I/O panel is just a 10-way ribbon cable wired
pin-to-pin, but any console cable intended for any of the boards above
should be fine for a direct connection, and you can set baud rate etc
directly on the KDJ11-B DIP switches.
--
Pete Peter Turnbull
Network Manager
University of York