13 Dec
2015
13 Dec
'15
7:46 a.m.
-----Original Message-----
From: cctalk [mailto:cctalk-bounces at classiccmp.org] On Behalf Of Holm
Tiffe
Sent: 11 December 2015 07:42
To: General Discussion: On-Topic and Off-Topic Posts
Subject: Re: VAX 4000-500 PSU Overload?
There is a big rectangular Cap in that PSU that I've left there since
I don't have a usable Replacement and the primary caps where still good so
far. The PSU itself is a really bad design from sight of repair, you can't
properly replace the caps on the switcher PCB since you could'nt dismount
the heat spreader so I suggest that you pull the Caps from above and
solder
new one from above as I finally did.
I have been able to remove the leaking ones from the +12V and -12V board, I
just have to wait for the new parts to arrive. The two on the 5V and 3.3V
board have not leaked, are not bulging, and are harder to remove without
removing the bottom heatsink or pulling from above as you suggest. I have
not been able to reach them with my ESR meter either, unfortunately. I am
tempted to leave them, although pulling from above is an option. Does anyone
else agree with the pull from above solution? In case you have not seen it,
the design makes it very hard to get at the underside, you have to desolder
a load of transistors to do so, and they are not in easy locations either.
Regards
Rob