2 Nov
2015
2 Nov
'15
1:44 p.m.
2015-11-02 22:05 GMT+01:00 Robert Jarratt <robert.jarratt at ntlworld.com>:
I have just uploaded all the corrections. So the connector names on the
risers should now correspond. I have also corrected the area on the primary
control module around C403 and R407.
Regards
Rob
Checked the new one. There are still something weird. The base of Q301 it
is short circuited to the emitter (which if that is true would of cause
your problem). But I think this is a drawing mistake. The base signals goes
to the D405 diode which is connected to emitter Q405 and emitter Q406 which
is then connected to emitter Q301... Please check this again. Maybe there
are a short circuit component that makes you trace it wrong (if you do it
by ohm-meter)
/Mattis