Barden programming books (was: Re: TRS-80 bootable media request)

At 17:20 -0600 2/25/10, Mike L. wrote: A comment and a question: I found on eBay the CoCo Assembly book by the same author. It's clear, an enjoyable read, and does a good job of introducing programming, the debugger/assembler implemented on the cartridge, and 6809 assembly language in a simple, easy-to-understand progression. However, it seems to me to give really short shrift to what the 6809 designers considered to be very important features of the processor. Position independent code is barely touched on, there are a lot of what looks to me like kludgy programming techniques, the most advanced software-management tool discussed is a flowchart (and then there's no useful example of how to use them), the multiple pointer registers are abused as 16-bit counters rather than as indexing pointers, and there are many similar examples. Does anybody else have the same take on this? I was thinking about using it to teach programming to one or more of the kids, but it seems to me that I'd rather find something a bit more structure-oriented, and less likely to use "tricks". Am I just spoiled from having read the 6809 programmer's guide and the (somewhat snooty-sounding) Byte article on 6809 design and introduction? -- - Mark 210-379-4635 ----------------------------------------------------------------------- Large Asteroids headed toward planets inhabited by beings that don't have technology adequate to stop them: Think of it as Evolution in Fast-Forward.